Robinson Brothers Ltd, West Bromwich

ESH supplied and installed both the trace heating and thermal insulation to provide temperature maintenance to stainless steel pipework within a Zone I hazardous area. The pipe required to maintain a temperature of +40°C. Our ATEX approved constant wattage heating cable, type SCBXT, was used throughout this project.

* Hazardous Area Trace Heating *

Plaxica (Wilton Centre), Redcar

Within a Zone I Hazardous Area, ESH designed, supplied and installed a temperature maintenance trace heating system to a section of 1" Ø vessel pipework. The pipework required to be maintained between +90°C and +150°C, this was achieved by straight tracing three runs of type SCBXC12/2 ATEX Approved constant wattage heating cable to the underside of each pipe.

* Hazardous Area Trace Heating *

Robert Sanderson & Sons Ltd, Hull

ESH supplied and install a trace heating system to temperature maintain a large HCA storage tank at +36°C in a minimum ambient of -20°C. The system, within a Zone II Hazardous Area, required over 150 metres of type SCBX ATEX approved constant wattage heating cable. 

* Type SCBX Hazardous Area Constant Wattage Cable *

Plaxica (Wilton Centre), Redcar

ESH were asked to test a damaged circuit and if necessary remove and replace. The damaged circuit, caused by others, had to be replaced with mineral insulated hazardous area constant wattage heating tape.

* Hazardous Area Trace Heating *